Flying PNG.GIF (1089 bytes)
Home Up

 

D&RGW Kitchen Car, 04013

Kitchen-Side.JPG (38824 bytes)

This car was a modified 30', 20 ton, 4000 series boxcar.  For the PNG kit, I used my standard 30' frame and scribed plywood. A lot of the hardware is common parts from my other kits.  New hardware is the lower corner braces, square nut truss rod bolts and smoke stack assembly. Also the blocking around the coupler pockets.

Kitchen-A-End.JPG (75744 bytes)

"A" end of the car. Door knobs are included in the kit.

Kitchen-B-End.JPG (60063 bytes)

Decals for the is kit are also available. They are printed by Stan Cedarleaf. The decal pack comes with instruction by Stan and a simple decal placement card made by myself.

 

 Part # PNG-030

Kit Form, less trucks and couplers..........................................................................................................................$85.00

********************* Pictures of couplers and trucks can be seen on the parts page ***********************************

Couplers, choice of Kadee # 835 or Accucraft 1:20.3 (with purchase of car or kit).............................................$5.00

Aristo / Delton truck frames with Sierra Valley Steel Wheels (with purchase of car or kit)..........................$35.00

Accucraft Die-Cast Steel 1:20.3 D&RGW 3' 7" trucks (with purchase of car or kit)...........................................$45.00

Accucraft trucks with PNG Ball Bearings installed (with purchase of car or kit).............................................$65.00

Stan Cedarleaf wet decals  (with car or kit purchase)...........................................................................................$10.00